The preset command is used to set the default preset for counts and
scans.
The syntax for the preset command is:
preset channel
value
OR
preset countfile path
Where one can individually specify any of the arguments. For
instance, "preset
monitor" followed by "preset 234"
is identical to "preset
monitor 234". The same is true for countfile path - i.e. "preset countfile"
followed by "preset
path" is identical to "preset countfile
path". For additional information about the use of
countfiles, see the How to use countfiles guide.
The
preset command can also be accessed from the GUI by selecting the Count Preset
tab from the Drive/Scan/Count
top-level tab. To set the default preset, the
green button at the bottom of the tab must be changed from "Monitoring ...
Click to allow changes" to "Changing ... click
to monitor". Then highlight
the green button on the right corresponding to the channel which you
would like to set as the preset channel, type in the appropriate preset
value, and click on the blue "Set Default
Preset" button.
